Front Door: Service and Repair
REMOVALAll Doors
1. Remove the door trim panel.
2. Remove the screws and the speaker.
Front Door
3. Disconnect the electrical connectors.
NOTE: Driver door shown, passenger door similar.
4. Remove the two nuts, the bolt and the inner front door support bracket.
5. Release the wiring harness locators.
Rear Door
6. Disconnect the electrical connector.
7. Release the wiring harness locators.
All Doors
8. Remove the grommet and wiring harness.
9. Remove the door check strap screws.
CAUTION: Do not close the door after the door check screws have been removed.
10. Mark the hinge location on the door.
11. Remove the hinge to door bolts and the door.
NOTE: An assistant is required to support the door during its removal.
INSTALLATION
All Doors
1. Position the door and install the hinge to door bolts.
2. Install the door check strap screws.
3. Install the grommet and the wiring harness.
Rear Door
4. Connect the electrical connector.
Front Door
5. Install the front door support bracket, the two nuts and the bolt.
6. Connect the electrical connectors.
All Doors
7. Install the screws and the speaker.
8. install the door trim panel.
9. Check the door for a flush fit to the body.