Idle Speed/Throttle Actuator - Electronic: Service and Repair

REMOVAL
1. Disconnect the battery ground cable.







2. Disconnect the electrical connector from the Idle Air Control (IAC) valve.







3. Remove the IAC valve.
1 Remove the bolts.
2 Lift and remove the IAC valve from the vehicle and discard the gasket.
4. Clean the gasket mating surfaces.

CAUTION: Do not use Carburetor Tune-up Cleaner D9AZ-19579-BA meeting Ford specifications ESR-M14P9-A or any other type of solvent as damage to the valve internal components may result.

NOTE: The engine control sensor wiring cannot be cleaned. If necessary, new wiring must be installed.

INSTALLATION
1. To install, reverse the removal procedure.
^ Install a new gasket.