Cable

REMOVAL

NOTE: 3.0L shown, 3.9L accelerator cable bracket is molded into the manifold. LH drive shown, RH drive similar.







1. Using a trim tool, disconnect the accelerator cable from the throttle body lever and accelerator cable bracket.
1 Disconnect the accelerator cable from the throttle body lever.
2 Depress the lock tab and rotate the fitting 90 degrees counterclockwise.
3 Slide the cable up and out of the bracket.







2. Disconnect the accelerator cable from the retaining clip.







3. Remove the hush panel.
1 Remove the nut.
2 Remove the pin-type retainers.
3 Disconnect the lamp from the hush panel.
4 Remove the hush panel.







4. Remove the accelerator cable.
1 Remove the bolts.
2 Disconnect the accelerator cable and remove.

CAUTION: Be careful not to kink or nick the cable core wire.

INSTALLATION
1. To install, reverse the removal procedure.

CAUTION: If the accelerator cable is to be reused, inspect the locking tabs of the cable end ball stud fitting. If the locking tabs are damaged or broken, a new accelerator cable must be installed.

NOTE: The accelerator cable assembly may be supplied in two pieces. It will be necessary to snap the pieces together prior to installation.