Glove Compartment: Service and Repair

REMOVAL
1. Disconnect the battery ground cable.







2. Remove the two pin-type retainers and the instrument panel insulator.
- Disconnect the courtesy lamp.







3. Remove the screw and the floor heat duct.







4. From under the instrument panel, release the assist cable from the glove compartment door arm.
5. Open the glove compartment.







6. Remove the instrument panel finish panel.
7. Pull up on the glove compartment door arms and lower the glove compartment door.







8. Remove the assist cable bracket screws.







9. Remove the screws and the glove compartment bin.
- Disconnect the electrical connector.







10. Remove the bolts and the glove compartment door.
- Disconnect the electrical connector.

INSTALLATION
1. To install, reverse the removal procedure.