Cylinder Head Assembly
| Cylinder Head Bolts The cylinder head bolts must be replaced with new bolts. They are tighten-to-yield design and cannot be re-used. | Stage 1 | 30 Nm (22 ft.lb) |
| Stage 2 | Rotate 90 degrees | |
| Stage 3 | Back out a minimum of one full turn (360 degrees) | |
| Stage 4 | 30 Nm (22 ft.lb) | |
| Stage 5 | Rotate 90 degrees | |
| Stage 6 | Rotate all bolts an additional 90 degrees | |
| LH Sequence | --- | |
| RH Sequence | --- | |
| Camshaft Cap Bolts | LH | 10 Nm (89 in.lb) |
| RH | 10 Nm (89 in.lb) | |
| Intake Manifold Bolts | Upper | 10 Nm (89 in.lb) |
| Lower | 10 Nm (89 in.lb) | |
| Exhaust Manifold Bolts To make sure of a seal, the manifold bolts must be tightened to the same specification two times. | Stage 1 | 20 Nm (15 ft.lb) |
| Stage 2 | 20 Nm (15 ft.lb) | |
| LH Sequence | --- | |
| RH Sequence | --- | |
| Cylinder Head Temperature Sensor | 11 ft.lb |