Daytime Running Lamp: Testing and Inspection

NOTE: The FEM must be reconfigured upon replacement. Refer to Module Communications Network (Information Bus).

1. Verify the customer concern by operating the DRL following these steps:
1 Place the ignition switch in the RUN position.
2 Place the autolamp switch in the OFF position.
3 Place the headlamp switch in the OFF or PARK position.
2. Verify the parking lamp operation.
1 Place the headlamp switch in the PARK position.
^ If at least one of the parking lamps operates correctly, proceed to the next step.
^ If none of the parking lamps operate, refer to Parking Lamps.
3. Verify the high beam headlamp operation.
1 Place the headlamp switch in the ON position.
2 Place the multifunction switch in the high beam headlamp position.
^ If the high beam headlamp operation is correct and the DRL operation is incorrect, install a new FEM; refer to Multifunction Electronic Control Module (General Module).
^ If the high beam operation is incorrect, refer to Headlamps.