Parking Brake Control: Service and Repair

Removal
1. Position the right front seat into the full forward position.
2. Remove the console.





3. Remove the transfer duct.





4. WARNING: The parking brake control will have spring tension on the tension arm and, if released inadvertently, can cause injury. Use care when working on or around the parking brake control when the tension arm is in the locked position. Failure to follow these instructions can cause personal injury.

Using a screwdriver, push down on the tension arm until it is fully depressed.





5. Move the tension arm down and release the screwdriver.





6. Remove the control retainers.
- Disconnect the parking brake switch connector.





7. Bend the retaining tab out of the way and remove the cable anchor pin.





8. Using a 13 mm line wrench, depress the conduit retaining prongs to remove the parking brake cable and conduit from the control. Remove the parking brake control.

Installation





1. To install, reverse the removal procedure.