ACM Self-Diagnostic Mode

NOTE: To enter speaker walk-around test or ACM self-diagnostic mode the ACM must be turned on and in radio tuner mode (AM/FM).

ACM self-diagnostic mode can only be entered while in speaker walk-around test.

1. To enter speaker walk-around test simultaneously press the ACM preset buttons 3 and 6.
2. The speaker walk-around test stops at each speaker and applies a different tone to each speaker for about 1-2 seconds. Each speaker is tested and displayed on the ACM in the following sequence: RF, LF, LR, RR, Subwoofer I, Subwoofer II.
3. The speaker walk-around test automatically continues and tests:
^ The antenna and displays ANTENNA II, for 5 seconds.
^ For speaker short. If a short is present, SPKR SHORT will be displayed.
^ For CD/DJ. The ACM display will show NO DJ if not present. The speaker walk-around test will end and the ACM will return to its previous setting.
4. ACM self-diagnostic mode has five tests available:
^ Preset button 1 = Audio internal/external SELF TEST. If SELF FAIL is displayed, press TUNE > to scroll view the DTCs stored. Refer to the ACM Diagnostic Trouble Codes (DTC) Index. Diagnostic Trouble Code Tests and Associated Procedures If system is ok SELF PASS is displayed.
^ Preset button 2 = View/Clear continuous Diagnostic Trouble Codes (DTCs). NO DTCS is displayed if no DTCs are retrieved. If DTCS FOUND is displayed press TUNE > button to view the DTCs retrieved. Refer to the ACM Diagnostic Trouble Codes (DTC) Index. Diagnostic Trouble Code Tests and Associated Procedures To clear all DTCs press the EJECT button. DTCS CLEAR will be displayed.
^ Preset button 3 = SIGNAL TEST. This test measures the average strength at the current tuner setting.
^ Preset button 4 = Software configuration level. This test queries each radio system controller for their software configuration level. SOFT LEVELS will be displayed upon completion of the query. Press TUNE> to scroll view the software configuration version level.






^ Preset button 5 = DISPLAY TEST. This test will light all the ACM display segments for 5 seconds then turn all segments off. when the test is complete DISPLAY TEST is displayed on the bezel.

5. To enter these tests, press the preset button desired while in the speaker walk-around test. This will abort the speaker walk-around test and start the selected test.
6. To exit ACM self-diagnostic mode, turn the ignition switch or ACM OFF.
7. If the concern remains and the fault is not detected, proceed to Symptom Chart to continue diagnostics. Diagnosis by Symptom