Instrument Panel - Radio Applique/Trim Panel
SPECIAL SERVICE TOOL(S) REQUIREDDescription Tool Number
Radio Removing Tool T87P-19061-A
Removal and Installation
1. Remove instrument panel finish panel.
2. Disconnect and remove radio chassis using Radio Removing Tool T87P-19061-A.
3. Disconnect the automatic temperature control sensor from the back of instrument panel finish panel.
4. Remove the four screws (two each side of instrument panel finish panel) by reaching down through the instrument panel finish panel hole.
5. Through the radio chassis opening, release the two snap tabs (one top and one bottom) and pull instrument panel finish panel from instrument panel.
6. To install, reverse Removal procedure. Tighten screws to 2-3 N.m (18-26 lb-in).