Ignition Coil Pack

REMOVAL
1. Disconnect ignition coils and radio ignition interference capacitors at wiring connectors.

Removing Ignition Wires At Coil Pack:

2. Disconnect ignition wires by squeezing locking tabs and twisting while pulling upward.
3. Remove four ignition coil retaining screws and remove ignition coils and radio ignition interference capacitors. Save radio ignition interference capacitors for reinstallation with ignition coils.

INSTALLATION

Ignition Coil Installation:

1. Position ignition coils and radio ignition interference capacitors to mounting bracket.
2. Install retaining screws and tighten to 5-7 Nm (40-61 in lb).
3. Apply Silicone Dielectric Compound D7AZ-19A331-A (Motorcraft WA-10) or equivalent meeting Ford specification ESE-M1C171-A to all ignition wire spark plug boots.

Ignition Cables:

4. Install each ignition wire connector to the proper terminal on the ignition coil. Make sure boots are fully seated.
5. Connect electrical connectors to the ignition coils and radio ignition interference capacitors.