Rear Door

Removal

1. Raise window to full-up position, if possible. If glass cannot be raised and is in a partially down or full-down position, it must be supported so that it will not fall into door well during window regulator electric drive removal.
2. Disconnect battery ground cable.
3. Remove door trim panel and watershield. Doors. Disconnect window regulator electric drive wiring leads.
4. Use 3/4 inch (1/4 inch pilot) hole saw and drill out three "dimples" to access window regulator motor retaining screws. Remove screws. Remove three window regulator electric drive mounting screws.

CAUTION: Prior to motor drive assembly removal, ensure that the regulator arm is in a fixed position to prevent dangerous counterbalance spring unwind.

Installation

1. Position the window regulator electric drive to the regulator and install the three screws snug--not tight.
2. Connect the window regulator electric drive wires at the connector and cycle the glass to ensure gear engagement. After the gears are engaged, tighten the three window regulator electric drive retaining screws to 5.6-9.6 N-m (50-84 lb-in).
3. Connect battery ground cable.
4. Check power window for proper operation.

NOTE: Verify that all drain holes at bottom of doors are open to prevent water accumulation over window regulator electric drive.

5. Install door trim panel and watershield.