Ignition Coil Pack

REMOVAL
1. Remove air cleaner outlet tube.
2. Disconnect ignition coils and radio ignition interference capacitor at wiring connectors.

Removing Ignition Wires At Coil Pack:

3. Disconnect ignition wires by squeezing locking tabs and twisting while pulling upward.

Ignition Coil:

4. Remove four ignition coil retaining screws and remove ignition coils and radio ignition interference capacitor. Save radio ignition interference capacitor for reinstallation with ignition coils.

INSTALLATION
1. Position ignition coils and radio ignition interference capacitor to mounting bracket.
2. Install retaining screws and tighten to 5-7 Nm (40-61 in lb).
3. Apply Silicone Dielectric Compound D7AZ-19A331-A (Motorcraft WA-10) or equivalent meeting Ford specification ESE-M1C171-A to all ignition wire spark plug boots.
4. Install each ignition wire connector to the proper terminal on the ignition coil. Make sure boots are fully seated.
5. Connect electrical connectors to the ignition coils and radio ignition interference capacitor.
6. install air cleaner outlet tube.