Console: Service and Repair

Removal and Installation
1. Remove gear selector handle.
2. Pull front finish panel up to disengage from two locating clips. Disconnect cigar lighter and lamp connectors. Remove gear selector trim panel.
3. Remove two screws retaining front finish panel of console to the front bracket of console.
4. Open console door and remove cover in bottom of tray, to gain access to two console-to-rear floor bracket retaining screws. Remove screws.
5. To remove, slide console rearward and up.
6. To install, reverse Removal procedure. Tighten screws to 1.5-1.9 N.m (13-17 lb-in).