GD10 Component Check Actuate to Soft Position

^ If required use a small blade screwdriver to rotate control tube on bottom of actuator to "H" (FIRM position).

^ Use a 12 volt power supply and connect negative lead to actuator pin 4 and the positive lead to pin 3 for 1 to 2 seconds. This procedure should rotate control tube on bottom of actuator to "S" position.

^ Did control tube rotate to "S" position?

YES -- GO to GD11.

NO -- REPLACE right rear shock actuator and REPEAT Service Bay Diagnostics. Reading and Clearing Diagnostic Trouble Codes