GC11 Component Check Actuate to Firm Position

GC11 COMPONENT CHECK ACTUATE TO FIRM POSITION

^ If required use a small blade screwdriver to rotate control tube on bottom of actuator to S (SOFT position).

^ Use a 12 volt power supply and connect negative lead to actuator Pin 3 and positive lead to Pin 4 for 1 to 2 seconds. This procedure should rotate control tube on bottom of actuator to H position.

^ Did control tube rotate to H position?

YES -- GO to GC12.

NO -- REPLACE left front shock actuator and REPEAT Service Bay Diagnostics. Reading and Clearing Diagnostic Trouble Codes