GB11 Component Check Actuate to Firm Position

GB11 COMPONENT CHECK ACTUATE TO FIRM POSITION

^ If required use a small blade screwdriver to rotate control tube on bottom of actuator to "S" (SOFT position).

^ Use a 12 volt power supply and connect negative lead to actuator Pin 3 and positive lead to Pin 4 for 1 to 2 seconds. This procedure should rotate control tube on bottom of actuator to "H" position.

^ Is control tube rotated to "H" position?

YES -- GO to GB12.

NO -- REPLACE right front shock actuator and REPEAT Service Bay Diagnostics. Reading and Clearing Diagnostic Trouble Codes