GB10 Component Check Actuate to Soft Position

GB10 COMPONENT CHECK ACTUATE TO SOFT POSITION

^ If required use a small blade screwdriver to rotate control tube on bottom of actuator to "H" (FIRM position).

^ Use a 12 volt power supply and connect negative lead to actuator Pin 4 and positive lead to Pin 3 for 1 to 2 seconds. This procedure should rotate control tube on bottom of actuator to "S" position.

^ Is control tube rotated to "S" position?

YES -- GO to GB11.

NO -- REPLACE right front shock actuator and REPEAT Service Bay Diagnostics. Reading and Clearing Diagnostic Trouble Codes