Roof

Center Finish Panel-Roof Console

Removal
1. Insert a small screwdriver in slot at rear of one reading lamp lens assembly. Push screwdriver rearward and pull down on lens. Remove lens assembly. Repeat for other reading lamp lens assembly.
2. Remove two center finish panel retaining screws. Pull finish panel down and disconnect all electrical connectors. Remove finish panel.

Installation
1. Connect all electrical connectors.
2. Place finish panel into position and install two retaining screws.







3. Snap reading lamp lens assemblies into place.

Console Assembly, Roof







Removal And Installation
1. Remove center finish panel.
2. Remove the two center screws that attach the console to the windshield header panel.
3. Remove RH and LH A-pillar garnish mouldings.
4. Remove the four A-pillar attaching screws.
5. Lower console and disconnect electrical connectors, from locating clip, if equipped with illuminated visors or moon roof.
6. With console on work bench, remove sun visors, sun visor release buttons and sockets, if necessary.
7. To install, reverse Removal procedure.