Front Sensors and Brackets

Removal

WARNING: THE ELECTRICAL CIRCUIT NECESSARY FOR SYSTEM DEPLOYMENT IS POWERED DIRECTLY FROM THE BATTERY. TO AVOID ACCIDENTAL DEPLOYMENT AND POSSIBLE PERSONAL INJURY, THE POSITIVE BATTERY CABLE MUST BE DISCONNECTED PRIOR TO SERVICING OR REPLACING ANY SYSTEM COMPONENTS.

1. Disconnect positive battery cable.
2. Disconnect and remove heated windshield relay (if so equipped) RH side.





3. Disconnect RH/LH front sensor electrical connector.
4. Remove two nuts retaining RH/LH front sensor to RH/LH fender apron and remove sensor.

Installation
1. Position RH/LH front sensor and wire lead in vehicle and secure sensor to RH/LH fender apron with two retaining nuts. Tighten nuts to 10.2-13.8 N.m (91-122 lb-in).
2. Connect RH/LH front sensor wire lead connector to connector.
3. Install heated windshield relay (if so equipped).
4. Connect positive battery cable.
5. Verify air bag indicator.