Rear

1. Remove rear axle shaft, as described elsewhere in this manual.
2. Install pinion bearing cone remover T71P-4621-B, or equivalent, between axle shaft flange and sensor ring.
3. Position axle in arbor press, then press axle from sensor ring.
4. To install, position sensor ring with recessed side facing inboard on axle, then install piston bearing cone remover T71P-4621-B, or equivalent, on axle shaft.
5. Place bar stock on top of axle flange, then press sensor ring onto axle shaft, until a gap of 2.48-2.55 inches remains between face of sensor ring and face of flange.
6. Install axle shaft.