Front Center Sensor

Removal

WARNING: THE ELECTRICAL CIRCUIT NECESSARY FOR SYSTEM DEPLOYMENT IS POWERED DIRECTLY FROM THE BATTERY AND BACKUP POWER SUPPLY. TO AVOID ACCIDENTAL DEPLOYMENT AND POSSIBLE PERSONAL INJURY, THE BATTERY GROUND CABLE AND BACKUP POWER SUPPLY MUST BE DISCONNECTED PRIOR TO SERVICING OR REPLACING ANY SYSTEM COMPONENTS.

1. Disconnect battery ground cable and backup power supply. Voltage at backup power supply will leak down in approximately 15 minutes after ground cable is disconnected or one minute if battery positive cable is grounded.
2. Remove sight shield.





3. Disconnect center front sensor electrical connector.
4. Remove four screws retaining center front sensor to radiator support. Remove sensor from vehicle.

Installation
1. Position front center sensor with arrow on top pointing toward front of vehicle and secure to radiator support with four retaining screws. Tighten screws to 3.3-4.5 N.m (29-40 lb-in).
2. Connect front center sensor wire lead connector to wiring assembly connector.
3. Install sight shield.
4. Connect backup power supply and battery ground cable.
5. Verify air bag indicator.