Door Pull Cover - Removal/Installation Procedure

90ford08

^ DOOR - INTERIOR PULL COVER - REMOVAL AND INSTALLATION PROCEDURE

^ TRIM - INTERIOR - DOOR PULL COVER - REMOVAL AND INSTALLATION PROCEDURE

Article No. 90-8-3

Figure 1:

LINCOLN-MERCURY: 1990 TOWN CAR


ISSUE: A door pull cover removal and installation procedure has been developed to avoid breakage.

ACTION: If service is required, use the following procedure to remove and install the interior door pull covers.

1. Insert a small screwdriver diagonally between the pull strap and the chrome bracket as shown in Figure 1.

2. Snap out one side of the cover by applying pressure outward from behind the door pull cover.

3. Snap out the other (opposite) side.

CAUTION: DO NOT ATTEMPT TO REMOVE THE DOOR PULL COVER AFTER SNAPPING OUT ONLY ONE SIDE OF THE COVER. BOTH SIDES MUST BE SNAPPED OUT WITH A SMALL SCREWDRIVER. FAILURE TO DO THIS COULD BREAK ONE OF THE SMALL RIDGES BEHIND THE DOOR PULL CAP.

4. To install, snap the cover back into place.

OTHER APPLICABLE ARTICLES: None
WARRANTY STATUS: INFORMATION ONLY
OASIS CODES: 1051, 1050, 1800