Rear

1. Disconnect sensor electrical connector in luggage compartment.
2. Push rubber grommet through sheet metal floor pan.
3. Turn air suspension switch in luggage compartment to the OFF position. Raise and support vehicle and remove retainer clips for sensor wire, then the wire from routing.
4. Loosen sensor attaching screw at caliper anchor plate.
5. Install tool T88P-5310-A or equivalent onto the front suspension arm. Using suitable breaker bar, lower the arm to provide clearance for the sensor wire connector to pass through. Remove sensor.
6. Reverse procedure to install.Torque sensor attaching screw to 40-60 inch lbs.