Oil Pressure Switch - Location Revision

91ford08

Article No. 91-5B-10


ELECTRICAL/VACUUM TROUBLESHOOTING MANUAL - 1988 - PAGE 30 AND PAGE 84 - OIL PRESSURE SWITCH ILLUSTRATION PROVIDED - OIL PRESSURE SWITCH FIGURE REFERENCE REVISED


LINCOLN-MERCURY: 1988 CONTINENTAL


ISSUE: The Component Location listing on Page 84 of the 1988 Continental Electrical/Vacuum Troubleshooting Manual incorrectly indicates the Oil Pressure Switch is shown in Figure 1 on Page 30.

ACTION: Refer to the pages following this TSB article for the updated Component Location listing and the added Figure 3 to Page 30 which shows the Oil Pressure Switch.


OTHER APPLICABLE ARTICLES: NONE
WARRANTY STATUS: INFORMATION ONLY
OASIS CODES: 290000

Figure 1:

Figure 2:

Figure 3:

30 CHARGE/POWER DISTRIBUTION
1988


TROUBLESHOOTING HINTS
CONDITION POSSIBLE CAUSE ACTION
^ Battery doesn't stay charged ^ Open or poor connection at ^ Check that connectors or
Alternator output or Voltage terminals on Alternator
Regulator Voltage Regulator and Starter
Relay are clean and tight
^ Check Fuse Link A and Fuse Link B
^ Alternator Warning Indicator is ^ Loose Alternator drive belt
^ Check Alternator belt tension always ON ^ Corroded Battery terminals
^ Check that battery post
terminals are clean. Check that
terminals cannot be easily turned by hand on battery
posts.





1988 DIGITAL CLUSTER 83






84 DIGITAL CLUSTER
1988