Removal

REMOVAL

1. REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY
2. REMOVE BATTERY SERVICE HOLE COVER LH
3. PRECAUTION

NOTICE: After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery negative (-) terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery negative (-) terminal notices before proceeding with work.

4. DISCONNECT CABLE FROM AUXILIARY BATTERY NEGATIVE TERMINAL

NOTICE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

5. REMOVE REAR LOWER SEAT CONSOLE BOX COVER (for 4-Passenger with Ottoman)







6. REMOVE ARMREST DOOR CAP (except 4-Passenger with Ottoman)
a. Using a thin-bladed screwdriver, detach the 6 claws.

HINT: Tape the screwdriver tip before use.

b. Detach the 2 hooks and remove the armrest door cap.







7. REMOVE SERVICE PLUG COVER
a. Remove the 4 bolts and service plug cover.

8. REMOVE SERVICE PLUG GRIP







CAUTION:
- Remove the service plug grip to interrupt a high voltage circuit at the time of the check.
- Keep the removed service plug grip in your pocket to prevent other technicians from accidentally reconnecting it while you are servicing the vehicle.
- All the high voltage wiring connectors are orange colored.

a. Wear insulated gloves. Slide the service plug grip upward, turn the lever downward, and then remove the service plug grip.

CAUTION: After disconnecting the service plug grip, wait for at least 10 minutes before touching any of the high-voltage connectors or terminals.

NOTICE: Never turn the power switch on (READY) with the service plug grip removed as malfunctions may occur.

HINT: Waiting for at least 10 minutes is required to discharge the high-voltage capacitor inside the inverter with converter assembly.