Installation

STEERING COLUMN: TILT AND TELESCOPIC MANUAL SWITCH: INSTALLATION

1. INSTALL TILT AND TELESCOPIC MANUAL SWITCH





(a) Attach the claw to install the tilt and telescopic manual switch.

(b) Connect the connector.

2. INSTALL STEERING COLUMN COVER (w/o Driver Monitor Camera)





(a) Attach the claw to install the upper steering column cover.

(b) Attach the 4 clips to install the upper steering column cover onto the instrument cluster finish panel.





(c) Attach the 2 claws to install the lower steering column cover.

NOTICE:
Do not damage the tilt and telescopic switch.

(d) Install the screw.

Torque : 2.0 Nm (20 kgf-cm, 18 in-lbf)





(e) Install the 2 screws.

Torque : 2.0 Nm (20 kgf-cm, 18 in-lbf)

HINT
Turn the steering wheel to the right and left as necessary to install the 2 screws.

3. INSTALL STEERING COLUMN COVER (w/ Driver Monitor Camera)





(a) Attach the clip to install the upper steering column cover.

(b) Attach the 4 clips.





(c) Attach the 2 claws to install the lower steering column cover.

NOTICE:
Do not damage the tilt and telescopic switch.

(d) Install the screw.

Torque : 2.0 Nm (20 kgf-cm, 18 in-lbf)





(e) Install the 2 screws.

Torque : 2.0 Nm (20 kgf-cm, 18 in-lbf)

HINT
Turn the steering wheel to the right and left as necessary to install the 2 screws.

4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
* Reset the AUTO TILT AWAY function setting to the previous condition by changing the customize parameter Programming and Relearning.
* When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

5. INSTALL BATTERY SERVICE HOLE COVER LH Installation

6. INSTALL DECK TRIM SIDE BOARD LH (w/o Spare Tire) Installation

7. INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY Installation

8. INSPECT SRS WARNING LIGHT

(a) Inspect the SRS warning light Diagnosis System.