Installation

2AZ-FXE COOLING: EXHAUST PIPE GAS CONTROL ACTUATOR: INSTALLATION

1. INSTALL EXHAUST PIPE GAS CONTROL ACTUATOR

(a) Apply engine coolant to the O-ring.





Text in Illustration





(b) Install the exhaust pipe gas control actuator and exhaust pipe gas control stopper.

NOTICE:
* Be sure to install the exhaust pipe gas control stopper in the correct direction.
* Check that the O-ring is not deformed, cracked or swollen.
* Be sure to install the exhaust pipe gas control actuator until it touches the exhaust pipe gas control stopper.
* When installing the exhaust pipe gas control actuator, do not push on the piston.
* Make sure that the exhaust pipe gas control actuator and the exhaust pipe gas control stopper are free of oil.

(c) Install a new gasket and the exhaust pipe gas control actuator case with the 3 bolts and 3 nuts.





Text in Illustration





Torque : 5.0 Nm (51 kgf-cm, 44 in-lbf)

NOTICE:
* Be sure to install a new gasket in the correct direction.
* Make sure that the exhaust pipe gas control actuator case and the new gasket are free of oil.

HINT
Install the gasket so that the protrusion is located as shown in the illustration.

(d) Check that there is clearance between the rod end and the lever.





(e) Connect the 2 water hoses.





2. ADD ENGINE COOLANT (for Engine) Service and Repair

3. INSPECT FOR COOLANT LEAK Testing and Inspection

4. INSTALL FRONT NO. 3 ENGINE UNDER COVER

5. INSTALL NO. 1 ENGINE UNDER COVER