Installation

L110 HYBRID TRANSMISSION / TRANSAXLE: TRANSMISSION CONTROL SWITCH: INSTALLATION

1. INSTALL TRANSMISSION CONTROL SWITCH

(a) Install the transmission control switch to the shift lever guide housing.

HINT
Securely engage the claws.

(b) Apply MP grease to the shaded area of the shift lever guide housing as indicated in the illustration.

NOTICE:
* Install the shift lever nut and lock pin after first engaging the 2 claws.
* Securely engage the claws.

(d) Connect the transmission control switch connector to the floor shift assembly.

2. INSTALL TRANSMISSION FLOOR SHIFT ASSEMBLY Installation

3. INSTALL FLOOR SHIFT GEAR SHIFTING ROD SUB-ASSEMBLY Installation

4. INSTALL FRONT FLOOR NO. 1 HEAT INSULATOR Installation

5. INSTALL FRONT FLOOR COVER CENTER RH

(a) Install the front floor cover center RH with the 3 grommets.

Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)

6. INSTALL FRONT EXHAUST PIPE ASSEMBLY Installation

7. INSTALL REAR FLOOR NO. 1 PANEL BRACE Installation

8. INSTALL FRONT FLOOR BRACE CENTER Installation

9. INSTALL HEATED OXYGEN SENSOR

(a) Install the heated oxygen sensor Installation.

10. INSTALL NO. 2 CONSOLE BOX DUCT Installation

11. INSTALL CONSOLE BOX ASSEMBLY Installation

12. INSTALL CONSOLE BOX REGISTER ASSEMBLY Installation

13. INSTALL CONSOLE BOX PLATE Installation

14. INSTALL INSTRUMENT PANEL FINISH PANEL END LH Installation

15. INSTALL INSTRUMENT PANEL FINISH PANEL END RH Installation

16. INSTALL UPPER CONSOLE PANEL ASSEMBLY Installation

17. INSTALL FRONT CONSOLE UPPER PANEL GARNISH Installation

18. INSTALL SHIFT LEVER KNOB Installation

19. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

20. INSTALL BATTERY SERVICE HOLE COVER LH Installation

21. INSTALL LUGGAGE COMPARTMENT FLOOR MAT

22. INSPECT SHIFT LEVER POSITION Adjustments

23. ADJUST SHIFT LEVER POSITION Adjustments

24. INSPECT SHIFT LEVER OPERATION Adjustments

25. CHECK FOR EXHAUST GAS LEAKS Installation

26. PERFORM INITIALIZATION

(a) Perform initialization Repair Instruction - Initialization.

NOTICE:
Certain systems need to be initialized after reconnecting the cable to the negative (-) battery terminal.