Removal

HYBRID BATTERY CONTROL: HV RELAY ASSEMBLY: REMOVAL

1. PRECAUTION

Service Precautions

2. CHECK DTC OUTPUT Removal

3. REMOVE LUGGAGE COMPARTMENT FLOOR MAT

4. REMOVE BATTERY SERVICE HOLE COVER LH Removal

5. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

6. REMOVE SERVICE PLUG GRIP Removal

7. REMOVE NO. 2 ENGINE ROOM SIDE RH COVER Removal

8. REMOVE CONNECTOR COVER ASSEMBLY Removal

9. CHECK TERMINAL VOLTAGE Removal

10. INSTALL CONNECTOR COVER ASSEMBLY Installation

11. INSTALL NO. 2 ENGINE ROOM SIDE RH COVER Installation

12. REMOVE LUGGAGE COMPARTMENT TRIM SIDE COVER RH

13. REMOVE TOOL BOX

14. REMOVE ROPE HOOK ASSEMBLY Removal

15. REMOVE LUGGAGE COMPARTMENT FRONT TRIM COVER Removal

16. INSTALL TOOL BOX

17. REMOVE NO. 3 HV BATTERY EXHAUST DUCT Removal

18. DISCONNECT FRAME WIRE Removal

19. REMOVE BATTERY BRACKET SUB-ASSEMBLY Removal

20. REMOVE BATTERY CARRIER SUB-ASSEMBLY Removal

21. REMOVE NO. 6 BATTERY CARRIER PANEL Removal

22. REMOVE HV RELAY ASSEMBLY

(a) Disconnect the 7 connectors and clamp from the HV relay assembly.





CAUTION:
Wear insulated gloves.

NOTICE:
Insulate the removed terminals with insulating tape.

(b) Remove the 3 nuts and HV relay assembly from the battery carrier.





CAUTION:
Wear insulated gloves.

23. REMOVE HIGH VOLTAGE FUSE

(a) Remove the 2 bolts and high voltage fuse.