Installation

SLIDING ROOF: SLIDING ROOF HOUSING: INSTALLATION

1. INSTALL SLIDING ROOF HOUSING ASSEMBLY

(a) Temporarily install the housing with the 4 bolts (vehicle body side) and 8 nuts.

CAUTION:
Be careful not to damage the curtain shield airbag when installing the housing.

(b) Tighten the nuts.

Torque : 5.5 Nm (55 kgf-cm, 48 in-lbf)

(c) Tighten the 4 bolts on the housing side of the stay.

Torque : 8.0 Nm (82 kgf-cm, 71 in-lbf)

(d) Tighten the bolts on the vehicle body side.

Torque : 8.0 Nm (82 kgf-cm, 71 in-lbf)

(e) Connect the 4 drain hoses.

2. INSTALL SLIDING ROOF GLASS ASSEMBLY

(a) Using a T25 "TORX" socket wrench, temporarily install the glass with the 4 screws.

(b) Adjust the roof glass position.

(1) Check the clearance between the roof glass and roof panel.

(2) Using a T25 "TORX" socket wrench, loosen the 4 screws and adjust the roof glass position.





Standard measurement:





NOTICE:
The clearance should be even all around.

(3) Check the clearance between the roof panel and roof glass.

(c) Tighten the 4 screws.

Torque : 5.5 Nm (56 kgf-cm, 49 in-lbf)

3. INSPECT FITTING OF SLIDING ROOF GLASS ASSEMBLY

(a) If a leak is found, readjust the sliding roof.

4. INSTALL ROOF HEADLINING ASSEMBLY

(a) Install the roof headlining Installation.

5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

6. PERFORM INITIALIZATION

(a) Perform initialization Repair Instruction - Initialization.

NOTICE:
Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.