Installation

AA80E AUTOMATIC TRANSMISSION / TRANSAXLE: TRANSMISSION CONTROL SWITCH: INSTALLATION

1. INSTALL TRANSMISSION CONTROL SWITCH

(a) Apply MP grease to the hatched area of the shift lever guide housing as indicated in the illustration.





(b) Install the transmission control switch to the shift lever guide housing.





NOTICE:
Securely engage the claws.

(c) Install the shift lever guide housing with the shift lever lock pin and a new shift lever support.





NOTICE:
* Install the shift lever nut and lock pin after first engaging the 2 claws.
* Securely engage the claws.
(d) Connect the transmission control switch connector to the floor shift assembly.





2. INSTALL TRANSMISSION FLOOR SHIFT ASSEMBLY Installation

3. INSTALL FLOOR SHIFT GEAR SHIFTING ROD SUB-ASSEMBLY Installation

4. ADJUST SHIFT LEVER POSITION Adjustments

5. INSTALL FRONT NO. 1 FLOOR HEAT INSULATOR Installation

6. INSTALL FRONT EXHAUST PIPE ASSEMBLY Installation

7. CONNECT HEATED OXYGEN SENSOR Installation

8. INSTALL FRONT CENTER FLOOR BRACE Installation

9. INSTALL REAR NO. 1 FLOOR PANEL BRACE Installation

10. INSTALL NO. 2 FLOOR UNDER COVER Installation

11. INSTALL NO. 1 FLOOR UNDER COVER Installation

12. INSTALL NO. 2 CONSOLE BOX DUCT Installation

13. INSTALL CONSOLE BOX Installation

14. INSTALL CONSOLE BOX REGISTER ASSEMBLY Installation

15. INSTALL REAR ASH RECEPTACLE ASSEMBLY Installation

16. INSTALL FRONT ASH RECEPTACLE ASSEMBLY Installation

17. INSTALL CONSOLE PANEL SUB-ASSEMBLY Installation

18. INSTALL UPPER NO. 2 CONSOLE PANEL GARNISH Installation

19. INSTALL UPPER NO. 1 CONSOLE PANEL GARNISH Installation

20. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY Installation

21. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Testing and Inspection.

22. INSPECT SHIFT LEVER POSITION Initial Inspection and Diagnostic Overview

23. INSPECT FOR EXHAUST GAS LEAK