Removal

2UR-GSE ENGINE CONTROL: ECM: REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Testing and Inspection.

2. REMOVE COOL AIR INTAKE DUCT SEAL Removal

3. REMOVE ENGINE ROOM SIDE COVER LH Removal

4. REMOVE V-BANK COVER SUB-ASSEMBLY Removal

5. REMOVE ENGINE ROOM ECU COVER

(a) Remove the 3 bolts and the ECM cover.





NOTICE:
* Remove all water from on and around the ECM cover.
* Perform the inspection indoors to avoid rain.
* Be sure to prevent water intrusion to the ECM (connectors and screw holes).
6. REMOVE ECM

(a) Disconnect the ECM connectors.

(1) Using a screwdriver, disconnect the connector holder.





(2) Disconnect the 6 ECM connectors.

(b) Remove the 2 nuts and ECM from the ECM box.