Installation

METER / GAUGE / DISPLAY: CLOCK: INSTALLATION

1. INSTALL CLOCK SUB-ASSEMBLY (w/o Navigation System)

(a) Connect the connector.

(b) Install the cover with the 9 screws.

(d) Install the panel with the 6 screws.

2. INSTALL RADIO RECEIVER ASSEMBLY (w/o Navigation System) Installation

3. INSTALL NO. 2 RADIO BRACKET (w/o Navigation System) Installation

4. INSTALL NO. 1 RADIO BRACKET (w/o Navigation System) Installation

5. INSTALL INTEGRATION CONTROL PANEL WITH RADIO RECEIVER ASSEMBLY (w/o Navigation System) Installation

6. INSTALL CLOCK ASSEMBLY (w/ Navigation System)

(a) Check that the wire harness is in the position shown in the illustration.

(b) Engage the 2 clips and install the clock assembly as shown in the illustration.

7. INSTALL RADIO RECEIVER ASSEMBLY (w/ Navigation System) Installation

8. INSTALL NO. 2 RADIO BRACKET (w/ Navigation System) Installation

9. INSTALL NO. 1 RADIO BRACKET (w/ Navigation System) Installation

10. INSTALL DISPLAY AND NAVIGATION MODULE DISPLAY WITH RADIO RECEIVER ASSEMBLY (w/ Navigation System) Installation

11. INSTALL CENTER LOWER INSTRUMENT CLUSTER FINISH PANEL Installation

12. INSTALL NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY Installation

13. INSTALL FRONT ASH RECEPTACLE ASSEMBLY Installation

14. INSTALL CONSOLE PANEL SUB-ASSEMBLY Installation

15. INSTALL UPPER NO. 2 CONSOLE PANEL GARNISH Installation

16. INSTALL UPPER NO. 1 CONSOLE PANEL GARNISH Installation

17. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY Installation

18. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

19. ADJUST CLOCK