Suspension Main Relay: Testing and Inspection

SUSPENSION CONTROL: SUSPENSION CONTROL RELAY: ON-VEHICLE INSPECTION

ON-VEHICLE INSPECTION

1. REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY Removal
2. REMOVE BATTERY SERVICE HOLE COVER LH Removal
3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.
- After the power switch is turned OFF, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the power switch OFF, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.

4. REMOVE SUSPENSION CONTROL RELAY (AIR SUS)
(a) Remove the suspension control relay from the engine room No. 5 relay block.
5. INSPECT SUSPENSION CONTROL RELAY





(a) Measure the resistance according to the value(s) in the table below.
Standard resistance:





If the result is not as specified, replace the suspension control relay.
6. INSTALL SUSPENSION CONTROL RELAY
7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 5.6 Nm (57 kgf-cm, 50in-lbf)
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

8. INSTALL BATTERY SERVICE HOLE COVER LH Installation
9. INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY Installation
10. CHECK SRS WARNING LIGHT
(a) Check the SRS warning light Diagnosis System.