Removal

PARK ASSIST / MONITORING: ULTRASONIC SENSOR (for Rear Side): REMOVAL

REMOVAL
NOTICE:
When replacing the sensor, only replace the clips and sensor.

1. REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY Removal
2. REMOVE BATTERY SERVICE HOLE COVER LH Removal
3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE:
- After the power switch is turned OFF, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the power switch OFF, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

4. REMOVE REAR BUMPER PLATE LH Removal
5. REMOVE REAR BUMPER PLATE RH Removal
6. REMOVE REAR BUMPER COVER Removal
7. REMOVE NO. 3 LUGGAGE ROOM WIRE
(a) Disconnect the sensor connectors.





(b) Detach the claws, and remove the wire harness together with the clips from the sensors.
(c) Remove the tape and wire harness (with the clips) from the bumper cover.
(d) Remove the clamps from the clips to remove the wire.





8. REMOVE NO. 1 ULTRASONIC SENSOR





(a) Remove the 4 sensors from the 4 sensor retainers as shown in the illustration.
- Be careful not to damage the retainer.
- Do not forcibly remove the retainer from the bumper cover.

9. REMOVE NO. 1 ULTRASONIC SENSOR RETAINER





(a) While heating the retainer using a dryer, pull the retainer lightly and remove the double-sided tape. Then remove the retainer.
Heating temperature:
40 to 60°C (104 to 140°F)
CAUTION:
Be careful of burns.

(b) Using a cloth or non-residue solvent, wipe off any tape residue on the bumper cover.