Installation

L110 HYBRID TRANSMISSION / TRANSAXLE: TRANSMISSION CONTROL SWITCH: INSTALLATION

INSTALLATION

1. INSTALL TRANSMISSION CONTROL SWITCH





(a) Install the transmission control switch to the shift lever guide housing.
HINT: Securely engage the claws.





(b) Apply MP grease to the shaded area of the shift lever guide housing as indicated in the illustration.





(c) Install the shift lever guide housing with the shift lever lock pin and a new shift lever nut.
- Install the shift lever nut and lock pin after first engaging the 2 claws.
- Securely engage the claws.





(d) Connect the transmission control switch connector to the floor shift assembly.
2. INSTALL TRANSMISSION FLOOR SHIFT ASSEMBLY Installation
3. INSTALL FLOOR SHIFT GEAR SHIFTING ROD SUB-ASSEMBLY Installation
4. INSTALL FRONT FLOOR NO. 1 HEAT INSULATOR Installation
5. INSTALL FRONT FLOOR COVER CENTER RH





(a) Install the front floor cover center RH with the 3 grommets.
Torque: 5.4 Nm (55 kgf-cm, 48in-lbf)
6. INSTALL FRONT EXHAUST PIPE ASSEMBLY Installation
7. INSTALL REAR FLOOR NO. 1 PANEL BRACE Installation
8. INSTALL FRONT FLOOR BRACE CENTER Installation
9. INSTALL HEATED OXYGEN SENSOR
(a) Install the heated oxygen sensor Installation.
10. INSTALL NO. 2 CONSOLE BOX DUCT Installation
11. INSTALL CONSOLE BOX ASSEMBLY Installation
12. INSTALL CONSOLE BOX REGISTER ASSEMBLY Installation
13. INSTALL CONSOLE BOX PLATE Installation
14. INSTALL INSTRUMENT PANEL FINISH PANEL END LH Installation
15. INSTALL INSTRUMENT PANEL FINISH PANEL END RH Installation
16. INSTALL UPPER CONSOLE PANEL ASSEMBLY Installation
17. INSTALL FRONT CONSOLE UPPER PANEL GARNISH Installation
18. INSTALL SHIFT LEVER KNOB Installation
19. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
20. INSTALL BATTERY SERVICE HOLE COVER LH Installation
21. INSTALL LUGGAGE COMPARTMENT FLOOR MAT
22. INSPECT SHIFT LEVER POSITION Adjustments
23. ADJUST SHIFT LEVER POSITION Adjustments
24. INSPECT SHIFT LEVER OPERATION Adjustments
25. CHECK FOR EXHAUST GAS LEAKS Installation
26. PERFORM INITIALIZATION
(a) Perform initialization Repair Instruction - Initialization.
NOTICE:
Certain systems need to be initialized after reconnecting the cable to the negative (-) battery terminal.