Installation

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: SKID CONTROL ECU: INSTALLATION

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: SKID CONTROL ECU: INSTALLATION

1. INSTALL SKID CONTROL ECU






(a) Install the skid control ECU with the 3 screws.
Torque: 5.5 Nm (56 kgf-cm, 49 in-lbf)
HINT:
- Align positioning boss (A) of the blower assembly with the hole of the skid control ECU.
- Securely engage hook (B) of the skid control ECU with the blower assembly.





(b) Connect the 3 connectors to the skid control ECU.
2. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Installation

3. INSTALL SIDE INSTRUMENT PANEL RH Installation

4. INSTALL FRONT DOOR OPENING TRIM COVER RH Installation

5. INSTALL FRONT DOOR SCUFF PLATE RH Installation

6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

7. PERFORM YAW RATE AND ACCELERATION SENSOR ZERO POINT CALIBRATION Testing and Inspection
8. CHECK FOR SENSOR SIGNAL Test Mode Procedure
9. CHECK AND CLEAR DTC
HINT: Reading and Clearing Diagnostic Trouble Codes