Installation
FRONT SUSPENSION: FRONT SUSPENSION MEMBER: INSTALLATION
FRONT SUSPENSION: FRONT SUSPENSION MEMBER: INSTALLATION
1. INSTALL POWER STEERING LINK ASSEMBLY
(a) Install the power steering link assembly with the 2 bolts, 2 washers, and 2 nuts.
Torque: 118 Nm (1203 kgf-cm, 87 ft-lbf)
HINT: Install the power steering link assembly together with the front lower suspension arm assembly.
2. INSTALL FRONT LOWER SUSPENSION ARM ASSEMBLY LH
(a) Install the front suspension lower arm assembly LH with the 2 bolts, 2 nuts and 2 washers.
Bolt B - Torque: 87 Nm (887 kgf-cm, 64 ft-lbf)
HINT: Install the power steering link assembly together with the front lower suspension arm assembly.
(b) Set the front lower suspension arm in the horizontal position shown in the illustration.
(c) Fully tighten the bolt A.
Bolt A - Torque: 135 Nm (1377 kgf-cm, 100 ft-lbf)
NOTICE: The final torque must be applied under standard vehicle height conditions.
3. INSTALL FRONT LOWER SUSPENSION ARM ASSEMBLY RH
HINT: Perform the same procedure as the LH side.
4. INSTALL FRONT STABILIZER BAR
(a) Install the front stabilizer bar with the 2 nuts.
Torque: 84 Nm (857 kgf-cm, 62 ft-lbf)
HINT: If the ball joint turns together with the nut, use a hexagon wrench (6 mm) to hold the stud bolt.
5. INSTALL FRONT ENGINE MOUNTING INSULATOR Installation
6. INSTALL FRONT SUSPENSION CROSSMEMBER SUB-ASSEMBLY Installation
7. INSTALL NO.2 EXHAUST MANIFOLD HEAT INSULATOR Installation
8. INSTALL NO.1 EXHAUST MANIFOLD HEAT INSULATOR Installation
9. INSTALL ENGINE UNDER COVER SUB-ASSEMBLY LH Installation
10. INSTALL ENGINE UNDER COVER SUB-ASSEMBLY RH Installation
11. INSTALL OIL LEVEL DIPSTICK GUIDE Installation
12. INSTALL OIL LEVEL DIPSTICK
13. INSTALL ENGINE WITH TRANSMISSION ASSEMBLY
HINT: Install the engine with transmission assembly. Installation