Rear Power Seat Control System
INITIALIZATION1. REAR POWER SEAT INITIALIZATION
NOTICE: The position sensor initialization must be performed if one of the following occurs: 1) the position control ECU is replaced or removed and installed; 2) the rear seat adjuster is replaced; or 3) the initialization cancel operation is performed.
a. Initialization cancel operation
1. Turn the engine switch on (IG).
2. Use the headrest operation to move the headrest to the lowermost position, use the slide operation to move the rear power seat to the foremost position, and continue the operation for 10 seconds or more. This will cancel the initialization.
b. Initialization operation
HINT:
- *: w/ Ottoman
- If the initialization is not completed, the buzzer will sound during the manual operation.
1. Perform the initialization cancel operation.
2. Use the slide operation to move the rear power seat to the rearmost lock position (buzzer sounds for 0.1 seconds).
3. Use the reclining* operation to move the rear power seat to the foremost lock position (buzzer sounds for 0.1 seconds).
4. Use the ottoman* operation to move the rear power seat to the lowermost lock position (buzzer sounds for 0.1 seconds).
5. Use the upper lumbar operation to move the upper seatback to the rearmost lock position (buzzer sounds for 0.5 seconds). The initialization is complete.