Entry Lock and Unlock Switch (For Front)

Entry Lock And Unlock (For Front):

ENTRY LOCK AND UNLOCK SWITCH (for Front)

REMOVAL

HINT:
- Use the same procedures for the LH side and RH side.
- The procedures listed below are for the LH side.

1. REMOVE COWL TOP VENTILATOR LOUVER RH
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTE: After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.

3. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG LH
4. REMOVE FRONT POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY LH
5. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH
6. REMOVE FRONT DOOR SERVICE HOLE COVER LH
7. REMOVE FRONT INNER DOOR GLASS WEATHERSTRIP LH
8. REMOVE FRONT DOOR GLASS SUB-ASSEMBLY LH
9. REMOVE FRONT DOOR OUTSIDE HANDLE COVER LH
10. REMOVE FRONT OUTSIDE DOOR HANDLE ASSEMBLY LH

INSTALLATION

HINT:
- Use the same procedures for the LH side and RH side.
- The procedures listed below are for the LH side.

1. INSTALL FRONT OUTSIDE DOOR HANDLE ASSEMBLY LH
2. INSTALL FRONT DOOR OUTSIDE HANDLE COVER LH
3. INSTALL FRONT DOOR GLASS SUB-ASSEMBLY LH
4. INSTALL FRONT INNER DOOR GLASS WEATHERSTRIP LH
5. INSTALL FRONT DOOR SERVICE HOLE COVER LH
6. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH
7. INSTALL MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY
8. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG LH
9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
10. INSTALL COWL TOP VENTILATOR LOUVER RH
11. PERFORM INITIALIZATION
a. Perform initialization.

NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.