Oil Pump Relay

OIL PUMP RELAY

ON-VEHICLE INSPECTION
1. INSPECT OIL PUMP RELAY
(a) Remove the intake duct seal.
(b) Remove the side cover.
(c) Remove the engine room No. 1 relay block cover.
(d) Remove the relay from the engine room No. 1 relay block.





(e) Using an ohmmeter, measure the resistance between each terminal.

Standard resistance:

If the result is not as specified, replace the relay.
(f) Install the relay to the engine room No. 1 relay block.
(g) Install the engine room No. 1 relay block cover.
(h) Install the side cover.
(i) Install the intake duct seal.