Fuel Gauge: Testing and Inspection

INSPECT FUEL RECEIVER GAUGE




a. Disconnect the connector from the sender gauge.
b. Connect terminals 1 and 2 on the wire harness side connector of the fuel sender gauge.
c. Turn the ignition switch to the ON position, then check the position of the receiver gauge needle.

OK: Needle position is on (EMPTY).

d. Connect terminals 2 and 3 on the wire harness side connector of the fuel sender gauge.
e. Turn the ignition switch to the ON position, then check the position of the receiver gauge needle.

OK: Needle position is on (FULL).