Central Junction Box (CJB)

Central Junction Box (CJB)
This is a "Trustmark Authoring Standards (TAS) Repair Procedure"
- TAS style procedures can be identified by steps that have no accompanying step text and the magenta color of the electrical connectors and fasteners such as nuts, bolts, clamps or clips.
- TAS removal and installation procedures use a sequence of color illustrations to indicate the order to be followed when removing/disassembling or installing/assembling a component.
- Many of the TAS procedures will have the installation information within the removal steps.
- The TAS color illustrations use a variety of symbols to indicate important details of the procedures. It is important to understand these symbols in order to properly used the TAS procedures.
Refer to How to Use TAS Procedures and TAS Symbol Glossary at Vehicle | Description and Operation for additional information on these TAS procedures.
For additional information, refer to How to Use TAS Procedures How to Use TAS Procedures

Removal

CAUTION: If a new component is to be installed, the Land Rover approved diagnostic equipment must be connected prior to removal, the data must then be downloaded from it and the keys (remote control handsets) set into default mode. Failure to follow this instruction will result in permanent damage to the keys.

CAUTION: A maximum of 4 remote transmitters can be programmed to the anti-theft alarm and double locking module. Programming for all remote transmitters must be carried out at the same time.

NOTE:
Removal steps in this procedure may contain installation details.

NOTE:
Make sure that all keys (remote control handsets) are present when performing this procedure.
1 If a new Central Junction Box (CJB) is to be installed, use Land Rover approved equipment to upload the stored data.
For additional information, refer to Specifications
For additional information, refer to Glove Compartment Service and Repair

Torque to: 8 Nm

Installation
1 To install, reverse the removal procedure.