Compressor/Pump: Service and Repair

Air Suspension Compressor

Removal

WARNING: Steps 1 and 2 must be carried out within 10 minutes of each other. Failure to follow this instruction may result in personal injury.

CAUTION: Before disconnecting or removing components, make sure the area around the joint faces and connections are clean. Plug open connections to prevent contamination.

NOTE:
Removal steps in this procedure may contain installation details.
1
CAUTION: Make sure the ignition switch is turned off, the park brake is on and the selector lever is in park.
Open the front door.
2
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
Raise and support the vehicle. Make sure at least one of the wheels is off the ground.
3 For additional information, refer to Air Suspension System Depressurize and Pressurize Air Suspension System Depressurize and Pressurize

5
CAUTION: Always plug any open connections to prevent contamination.

6
CAUTION: Always plug any open connections to prevent contamination.

7
NOTE:
Note the orientation of the component prior to removal.

Installation
1
NOTE:
Check the air compressor type. If an AMK air compressor is installed to replace an Hitachi air compressor then a new corresponding relay must also be installed.
For additional information, refer to Specifications

2
CAUTION: Using a suitable tap, cut a starting thread to align the self tapping bolts.

3
CAUTION: Make sure that these components are installed to the noted removal position.
CAUTION: Make sure that the self tapping bolts remains aligned during the tightening process.
TORQUE: 15 Nm

6 TORQUE: 9 Nm
7 For additional information, refer to Air Suspension System Depressurize and Pressurize Air Suspension System Depressurize and Pressurize