Direction Control Valve Solenoid

Direction Control Valve Solenoid

Removal
1
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
Raise and support the vehicle.
2 Remove the valve block. For additional information, refer to Valve Block Valve Block




3 Remove the solenoid.
- Remove the solenoid nut.
- Remove and discard the O-ring seal.

Installation





1 Install the solenoid.
- Install the O-ring seal.
- Tighten to 12 Nm.
2 Install the valve block. For additional information, refer to Valve Block Valve Block
3 Bleed the dynamic response system. For additional information, refer to Active Stabilization System Bleeding Active Stabilization System Bleeding