Selector Shaft Seal

Selector Shaft Seal

Special Service Tools






ZF Automatic transmission selector shaft seal remover

307-509-1 (LRT-44-033/1)





ZF Automatic transmission selector shaft seal remover

307-509-2 (LRT-44-033/2)





ZF Automatic transmission selector shaft seal installer

307-509-3 (LRT-44-033/3)

Removal
1
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
Raise and support the vehicle.
2 LH selector shaft seal only: Remove the exhaust system. For additional information, refer to Exhaust System Service and Repair




3 Remove the transmission heat shield.
- Remove the 4 bolts.




4 Release the selector cable and lever.
- Remove the nut.
- Compress the latch and release the cable.




5
CAUTION: Before the disconnection or removal of any components, ensure the area around joint faces and connections are clean. Plug any open connections to prevent contamination.
Remove the selector shaft seal.
- Install 307-509-1 to the seal.
- Install 307-509-2 to 307-509-1 and extract the seal.

Installation





1 Using 307-509-3, install the selector shaft seal.
- Clean the components.
2 Install the selector cable and bracket.
- Secure with the clip.
- Tighten the nut to 12 Nm (9 lb.ft).
3 Install the transmission heat shield.
- Install the bolts.
4 LH selector shaft seal only: Install the exhaust system. For additional information, refer to Exhaust System Service and Repair