Windshield Wiper Motor

Windshield Wiper Motor

Service Repair No - 84.15.12

Removal

1. Remove the plenum chamber panel.
2. Remove the windshield wiper motor and linkage.
^ Remove the 2 bolts.
^ Remove the 2 clips.
^ Disconnect the electrical connector.





NOTE: Do not disassemble further if the component is removed for access only.

3. Noting the fitted position, remove the wiper linkage.
^ Remove the 2 bolts.
^ Remove the nut.





Installation
1. Install the wiper linkage.
^ Tighten the bolts to 10 Nm (7 lb.ft).
^ Tighten the nut to 25 Nm (18 lb.ft).

CAUTION: Make sure the windshield wiper motor is located on its stud prior to installing the bolts.

2. Install the windshield wiper motor and linkage.
^ Tighten the bolts to 6 Nm (4 lb.ft).
^ Connect the electrical connector.
^ Install the clips.
3. Install the plenum chamber panel.