Rear Window Wiper Motor

Rear Window Wiper Motor

Service Repair No - 84.35.12

Removal
1. Disconnect the battery ground cable.
2. Remove the rear window wiper arm.
3. Remove the liftgate glass wiper motor trim panel.
^ Carefully release the 4 clips.





4. Remove the trim panel retaining plate.
^ Remove the 3 nuts.





5. Remove the rear window wiper motor.
^ Disconnect the electrical connector.
^ Remove the 3 nuts.





NOTE: Do not disassemble further if the component is removed for access only.

6. Remove the rear wiper drive spindle seal.





7. Remove the 3 rubber insulators.
^ Remove the metal inserts.





Installation
1. Install the rubber insulators.
2. Install the rear wiper drive spindle seal.
^ Clean the component mating faces.
3. Install the rear window wiper motor.
^ Tighten the nuts to 10 Nm (7 lb.ft).
^ Connect and secure the electrical connector.
4. Install the trim panel retaining plate.
^ Tighten the nuts to 6 Nm (4 lb.ft).
5. Install the liftgate glass wiper motor trim panel.
^ Carefully secure the clips.
6. Install the rear wiper arm.
7. Connect the battery ground cable.