Rear Door Fixed Window Glass

Rear Door Fixed Window Glass

Service Repair No - 76.31.31

Removal

1. Remove the rear door window motor and regulator assembly.
2. Lower the rear door glass to the bottom of the door.
^ Remove the wedge.

3. Remove the rear door frame trim.
^ Carefully release the adhesive strip.





4. Carefully remove the inner waist seal.





5. Release the lining from the glass rear guide channel.





6. Remove the rear door window fixed glass.
^ Remove the 2 Torx screws.
^ Release the 2 clips.





Installation

1. Install the rear door window fixed glass.
^ Clean the component mating faces.
^ Secure the 2 clips.
^ Tighten the Torx screws to 10 Nm (7 ft. lbs.).

2. Install the guide channel lining.
3. Install the inner waist seal.
4. Install the door frame trim.
^ Clean the component mating faces.
^ Remove backing tape from adhesive strip.

5. NOTE: Wedge the glass in this position.

Raise the rear door glass fully.
^ Engage the door glass with the channel.

6. Install the rear door window motor and regulator assembly.