Side Air Curtain Module

Side Air Curtain Module

Service Repair No - 76.74.40

Removal

WARNING:
^ It is imperative that before any work is undertaken on the SRS system, the appropriate information is read thoroughly.
^ Always disconnect both battery cables before beginning work on the SRS system. Disconnect the ground cable first. Never reverse connect the battery.

NOTE: If the SRS component is to be replaced, the bar code of the new unit must be recorded.

1. Disconnect the battery ground cable.
2. Make the SRS system safe.
3. Remove the headliner.
4. Release the roof opening panel drain tube from the securing clips.
^ Release from the 2 clips.
^ Remove and discard 2 cable ties.





NOTE: If the SRS component is to be replaced, the bar code of the new unit must be recorded.

5. With assitance, remove the side air curtain module.
^ Disconnect the electrical connector.
^ Remove the 9 Torx bolts.
^ Remove the 2 screws.





Installation

1. With assistance, install the side air curtain module.
^ Tighten the Torx screws to 10 Nm (7 lb.ft).
^ Tighten the screws.
^ Connect the electrical connector.
2. Secure the roof opening panel drain tube into the clips.
^ Install new cable ties.
3. Install the headliner.
4. Connect the battery ground cable.